Select Page

ProArloCamerasPro Arlo Camera | Pro Arlo camera setup | Pro Arlo Wire Free Camera | Pro Arlo Camera Support | Connect pro arlo Camera sans wire | Netgear Arlo Camera setup | Arlo Security Camera | Arlo sans wire camera | I set up Arlo Camera | Arlo ultra battery life

This article applies to:

VMB3000 VMB3500 VMB4000 VMB4500 VMC3030

These directions apply to setting up Arlo Wire-Free cameras with both Arlo base stations and Arlo Pro base stations. On the off chance that you sync Arlo Wire-Free cameras with an Arlo Pro base station, the Arlo Wire-Free cameras can get to the Arlo Pro base station’s highlights: the alarm and the USB nearby reinforcement stockpiling alternative.

To set up and synchronize Arlo Wire-Free cameras:

Open the battery compartment by sliding and holding the hook.

  1. Slide the battery entryway back and lift it to open the compartment.

Addition the batteries as appeared and close the battery entryway.

2.Carry the camera inside one to three feet (30 to 100 centimetres) of the base station.

Sync the camera to the base station:

On the off chance that you are utilizing an Arlo base station, press the Sync button as an afterthought or on the rear of the base station for around two seconds and afterward discharge the catch.

Note: If you press the Arlo Wire-Free Sync button on the base station for a really long time, the LED under the USB image flickers golden for 10 minutes. While the USB LED is flickering golden, the sync procedure is blocked.

On the off chance that you are utilizing an Arlo Pro base station, press the catch on the head of the base station for around two seconds and afterward discharge the catch.

Hang tight for the sync status LED to flicker green.

Press the Sync button on head of the camera for around two seconds and afterward discharge the catch.

4. Note: Cameras must be adjusted each in turn.

A blue LED on the camera flickers quickly to affirm sync.

5. In the event that the LED on the camera squints golden, the sync isn’t effective. You should rehash the sync procedure.

Check the camera LED on the base station.

In the event that the camera LED on the base station turns strong green, the sync procedure is finished.

Rehash these means for every camera.

Note: If you don’t finish the sync procedure inside 60 seconds, press the Sync button on the base station and attempt once more.

In the event that you can’t synchronize your cameras, visit My camera won’t sync with the base station; how might I investigate it?.

Pro Arlo Camera | Technical Arlo Camera Support | Pro Arlo camera setup | Arlo Camera setup | Pro Arlo Camera Support | Connect pro arlo Camera | Netgear Arlo Camera setup | Arlo Security Camera | Arlo sans wire camera | I set up Arlo Camera | Arlo ultra battery life